Dogtek BC-60 Spécifications télécharger pdf (Page 3)

www.dogtek.com

20 AWG or 18 AWG wire can be used (it is not recommended to combine dierent types of wire).

The wire sections recommended depending on the length of the system are as follows:

• forlessthan3000feetofantennawire:20AWG

• formorethan3000feetofantennawire:18AWG

From the transmitter, unroll the wire around the perimeter you wish to protect. To run the wire from your

garage or garden shed, pass it through a window, door or similar.

The wire can be placed on the ground, buried (maximum: 4 inches deep) or xed to a non-metallic existing

fence or wall (best height: your dog’s neck height). If you plan on burying the wire, make sure your installation is

functioning properly before doing so. You can protect the wire by running it through PVC pipe or a garden hose.

The wire must not be taut as variations in

temperature may cause it to expand or contract. In the

corners, do not make right angles but rounded corners

with a large radius.

Separate the wire by at least 6 feet from a metallic

gate or 3 feet from a metallic fence.

Do not install the antenna wire near an electrical

cable, telephone cable, television cable or satellite

dishes.

In order to prevent any interference, do not run the

wire within 6 feet or parallel to electrical cables. If you must cross electrical wires, telephone wires or television

cables, do so at 90 degree angles.

3 4

If you need more than 500 feet of antenna wire,

you must connect the dierent lengths of wire using

the supplied connectors (the wire does not need to

be stripped). You can purchase additional wire and

connectors from DOGTEK or your retailer.

To ensure your dog does not receive any warning or

stimulation in certain areas (e.g. between the transmitter

in the garage and the edge of your property) you have to

twist the outward wire around the inward wire. The twists prevent radio waves from being emitted.

Once the loop is completed and you are back at the

transmitter, strip the two ends of the wire to connect

them to the supplied transmitter connector (connect

each wire with each connector screw). Then, insert

this connector into the antenna socket located on the

transmitter.

INTRODUCTION

The understanding between a dog and his owner has existed since a long time.

Nonetheless, a dog is often guided by his natural instincts and breaks the rules is master has taught

him, causing complaints about straying and damages such as: damage to owerbeds, jumps into swimming

pools, etc. More seriously, he may be the victim or the cause of road accident.

The EF-6000 pet fencing system is a modern and highly eective system enabling you to keep one or

more dogs in complete freedom within a perimeter, fenced or unfenced, you have dened.

CONTENTS OF THE EF6000

• rechargeablecollarttedwithshortcontactpoints

• strapforthecollar

• batterychargerforthecollar

• transmitterwithACpoweradapter

• 500feetrollofantennawire

• connectionkitincluding3antennawireconnectorsand1transmitterconnector

• setof50boundaryags

• magnetickey

• neontestlamp

• pairoflongcontactpoints

• thisuser’sguide

HOW THE PET FENCING SYSTEM WORKS

You can dene your dog’s play area by installing a wire, called antenna wire, around the authorized

perimeter. This wire placed on the ground, buried or raised on an existing fence carries a radio signal from

the transmitter.

When your dog, wearing a receiver collar, approaches this wire, he is warned by beep sounds that he is

too close to an area where he is not allowed; then if he carries on, static stimulations will be emitted by the

collar. Your dog will have to leave the unauthorized area to stop the stimulations and beep sounds.

An unlimited number of receiver collars can be used with one transmitter: you can keep as many dogs

as you wish safely in the same area.

The EF-6000 pet fencing system has been designed to give you complete satisfaction with an antenna

wire up to a maximum length of 5000 feet (equivalent to 35 acres).

INSTALLING THE PET FENCING SYSTEM

1. Transmitter

The transmitter must be installed indoors in a dry location: the transmitter can withstand changes in

temperature but will be damaged by water. Make sure the transmitter is correctly xed (for example

screw it to a wall).

Install the transmitter in a garage or garden shed near an electrical outlet.

2. Antenna wire

For the system to operate, the wire must be connected to the transmitter and form a continuous loop

from the transmitter and back again. The outward and inward wires must be spaced at least5 feet apart

to avoid cancelling the signal.

Boundary

Wire

Buried Cable

Twisted wires

Boundary Wire

Wire connectors

Correct

Incorrect

6”

1 2 3 4 5 6 7 8 ... 24 25

Commentaires sur ces manuels

Pas de commentaire

Dogtek BC-60 Spécifications Page 3

Commentaires sur ces manuels

Produits connexes et manuels pour Soins des animaux Dogtek BC-60